Engineering resources

Which Bore Should You Specify for a Press-Fit PM Bushing?

Updated 19 November 2026

If the shaft must run freely after installation, specify the housing and the condition in which the bore is measured.

A shaft slides through a loose bushing on the inspection bench. After the bushing is pressed into its housing, the same shaft feels tight. Which measurement decides whether the supplier has delivered a good part? That depends on the assembly condition named on the drawing.

Mark the condition beside the bore dimension

The free bore is measured on the loose bushing. The installed bore is measured after pressing it into the specified housing or an agreed test ring. An interference fit can reduce the bore diameter. If running clearance matters in service, identify the installed bore requirement and the mating shaft limits. Give any free-state limits their own drawing callout.

Send the housing detail with the RFQ

Include the housing bore tolerance, material and wall section, alongside the bushing outside diameter, wall thickness and installed depth. A supplier checking a bushing in a rigid steel ring needs to know if the production housing is thin-walled or made of a different material. Agree on whether that ring represents the assembly before using its results for acceptance.

Agree what the first-sample report should record

For a trial, identify each sample and record its free bore and outside diameter. Record the actual housing bore, install the bushing using the agreed tooling, then check the installed bore at the specified depths. A plug gauge can answer a limit question. If the engineer needs to understand taper or ovality, agree on a measurement method that reports those features.

Make the quotations comparable

Say who will supply the trial housings and who will perform the installed check. Ask each supplier to identify any gauge, fixture or additional sizing cost. That makes it easier to compare two offers when one includes assembled inspection and the other covers loose parts only.

Bushings and structural PM parts · Discuss a bushing drawing

Technical reference: Oilite bearing press-fit and bore close-in calculators.

Assign responsibility for the installed-bore test

A useful purchase-order line identifies who supplies the representative housing, who installs each sample and which report records the installed result. Agree this before sample shipment so the receiving team can reproduce the check.